![]() Zebra shall not be responsible for any damage to or loss of any Software programs, data or removable data storage media, or the restoration or reinstallation of any Software programs or data. No charge will be made to End-User Customer for warranty repairs. Zebra shall be responsible for return shipment to End-User Customer, unless Zebra, in Zebra’s sole and absolute discretion, determines that the corresponding Hardware has no defect or is not under warranty, in which case End-User Customer shall be responsible also for return shipment. End-User Customer is responsible for shipment to Zebra and assumes all costs and risks associated with this transportation. The sole obligation of Zebra for defective Hardware is limited to repair or replacement (at Zebra's sole discretion) on a "return to service depot" basis with Zebra’s prior authorization. Unless otherwise stated by Zebra in the Product warranty exceptions list or in a sales agreement between Zebra and End-User Customer, Hardware is warranted for a period of twelve (12) months from date of shipment from Zebra or, with proof of purchase, from the purchase date whichever is later, against defects in workmanship and materials, provided the Hardware remains unmodified and is operated under normal and proper conditions and in accordance with Zebra published specifications. “Software” means, collectively, any Zebra provided machine-readable instructions used by a processor to perform specific operations other than machine-readable instructions used for the sole purpose of booting the Hardware during startup.“Product” means Zebra branded Hardware, Software or replacement parts.“Hardware” means the physical, tangible Product purchased from Zebra including machine readable instructions provided for the sole purpose of booting the Hardware during startup.“End-User Customer” means the original user of the Product.Push the lid closed until both yellow latches snap shut.Zebra Technologies Corporation, including affiliates and subsidiaries under Zebra’s common control (“Zebra”), warrants to the End-User Customer as follows:.Flip the labels up and align the movable sensor to the center position.Pull the labels out past the cutter at the front of the printer.Make sure the label roll is secure and turning freely. Release the roll guides and push them together.Pull the yellow roll guides apart and insert the label roll with the labels facing upwards.Pull the yellow latches on both sides of the printer towards you and lift the printer's lid open.To fix this error, change the label roll in your printer: If your printer is out of labels, you will see the below error message: If you're printing from your computer with Lightspeed Hub, the status of your printer will also update from Cover open to Connected in Lightspeed Hub and on the Devices page in Retail POS. You should now be able to print labels again. Push the cover closed until both yellow latches snap shut.To fix this error, make sure the cover of your printer is securely shut: If the cover of your printer is open, you will see the below error message in Retail POS: Using a USB hub or a power cord/bar could cause connection issues with Retail POS and Hub. Note: We recommend connecting your printer directly to a USB port on your computer and directly to an electrical outlet. If you're printing from your computer with Lightspeed Hub, the status of your printer will also update from Disconnected to Connected in Lightspeed Hub and on the Devices page in Retail POS. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |